Xadow - Vibrator Motor

Introduction

This small vibrator motor can vibrate like your phone. When using it, you only need to power for the module and then send “Vibration” command. In fact, the “Vibration” command is setting control pins to high level, then it will work. I like this module because it can create a short-term shock to prompt me whether one operation was successful, such as shaking my arm to switch my iPhone songs, which sounds terrible, but it does not like the buzzer.

Specification

  • working voltage: 3.3V

  • Rated Speed: 9000rpm

  • controlled by two digital signals

  • Dimensions: 25.43mm x 20.35mm

Demonstration

Here is a Demo Code showing how to turn on the vibration motor.

Hardware Installation:

Note: when connect Xadow Vibrator Motor to Xadow Main Board, you should concern about the connection direction. The connection method is that the unfilled corner of one Xadow module need to connect to the right angle of another module(see four corners of each Xadow module). Demo code like this:

<pre>
void setup()
{
    DDRF |= 0x01;
    DDRB |= 0x04;
}

void loop()
{
    //turn on the vibration motor
    PORTF |= 0x01;
    PORTB |= 0x04;
    delay(1000);
    //turn off the vibration motor
    PORTF &amp;= ~(0x01);
    PORTB |= 0x04;
    delay(1000);
    //turn on the vibration motor
    PORTF |= 0x01;
    PORTB |= 0x04;
    delay(1000);
    //turn off the vibration motor
    PORTF |= 0x01;
    PORTB &amp;= ~(0x04);
    delay(1000);
    //turn on the vibration motor
    PORTF |= 0x01;
    PORTB |= 0x04;
    delay(1000);
    //turn off the vibration motor
    PORTF &amp;= ~(0x01);
    PORTB &amp;= ~(0x04);
    delay(1000);
}</pre>

Resources

Xadow Vibrator Motor Eagle File

Help us make it better

Welcome to the new documentation system of Seeed Studio. We have made a lot of progress comparing to the old wiki system and will continue to improve it to make it more user friendly and helpful. The improvement can't be done without your kindly feedback. If you have any suggestions or findings, you are most welcome to submit the amended version as our contributor via Github or give us suggestions in the survey below, it would be more appreciated if you could leave your email so that we can reply to you. Happy Hacking!