Xadow - Gesture v1.0

Introduction

The sensor on Xadow - Gesture v1.0 is PAJ7620U2 that integrates gesture recognition function with general I2C interface into a single chip. It can recognize 13 gestures including move up, move down, move left, move right, move forward, move backward,circle-clockwise, circle-counter clockwise, up to down ,down to up,left to right ,right to left and wave. These gestures information can be simply accessed via the I2C bus.

Features

  • 13 gesture recognition
  • Gesture speed is 60°/s to 600°/s in Normal Mode and 60°/s to 1200°/s in Gaming Mode
  • Ambient light immunity: < 100k Lux
  • Built-in proximity detection
  • I2C interface up to 400 kbit/s
  • Compatible with the Xadow interface

Specification

  • Sensor:PAJ7620U2
  • Power supply:2.8V to 3.3V and I/O voltage is 1.8V~3.3V
  • Compatible: Xadow interface
  • Interface:IIC
  • Operating Temperature: -40°C to +85°C

  • Dimensions:25 * 20mm;

Interface Function

  • P1:Short-circuits,then interrupt signal will be connected with pin PF0/A5 .
  • U1:PAJ7620U2;Integrated Gesture Recognition Sensor.
  • J1,J2:FPC interface.

Note

When connect Xadow - Gesture to Xadow Main Board, the connection direction should be cautious. The connection method is that the unfilled corner of one xadow module connect to the right angle of another module(see four corners of each xadow module).

Pins Description

Pins on both sides of Xadow modules are symmetrical, here are pins descriptions about Interface from top to bottom.

Xadow Pins PAJ7620U2 Pins Function
1 NC (PCINT1/SCLK)PB1
2 NC (PDI/PCINT2/MOSI)PB2
3 NC (PDO/PCINT3/MISO)PB3
4 3/INT PF5(ADC5/TMS)
5 1/VBUS , 11/VLED , 12/VDD VCC
6 6/GND , 10/GND GND
7 6/GND , 10/GND GND
8 1/VBUS , 11/VLED , 12/VDD VCC
9 5/SCL (OC0B/SCL/INT0 )PD0
10 2/SDA (SDA/INT1)PD1
11 NC (RXD/INT2)PD2
12 NC (TXD/INT3)PD3

Resources

Help us make it better

Welcome to the new documentation system of Seeed Studio. We have made a lot of progress comparing to the old wiki system and will continue to improve it to make it more user friendly and helpful. The improvement can't be done without your kindly feedback. If you have any suggestions or findings, you are most welcome to submit the amended version as our contributor via Github or give us suggestions in the survey below, it would be more appreciated if you could leave your email so that we can reply to you. Happy Hacking!