Grove - NunChuck

Introduction

The Grove - NunChuck is a small PCB that adapts the Wii Nunchuck connector to standard Grove connector. The power, ground and two-wire interface of the Nunchuck are all broken out to a 4-pin 0.1” pitch header. This “Grove - NunChuck”, let you play with the Wii Nunchuck and other Wii remote peripherals without needing you to cut cables. Just plug it into the Wii Nunchuck, then into the Grove - Base Shield.

There is Wiichuck- A Wii-Nunchuck break out board, they are similar.

• Designed to be inserted into the connector of a Nintendo Wii Nunchuck

• Connects to Grove - Base Shield

• Interface Type: I2C

• Work Voltage: +5 V

Resource File: Grove - NunChuck Eagle File

If you have questions or other better design ideas, you can go to our forum or wish to discuss.

Help us make it better

Welcome to the new documentation system of Seeed Studio. We have made a lot of progress comparing to the old wiki system and will continue to improve it to make it more user friendly and helpful. The improvement can't be done without your kindly feedback. If you have any suggestions or findings, you are most welcome to submit the amended version as our contributor via Github or give us suggestions in the survey below, it would be more appreciated if you could leave your email so that we can reply to you. Happy Hacking!