Grove - FM Receiver

Introduction

3.3V 5.0V Digital

Grove - FM Receiver is a wideband FM receiver module, this module is base on SX6119, it offers true single-chip voice FM receiver, which is built-in amplifier, VCO, filter and demodulator. The multifunction button provides greater convenience for users to control.

Features

  • Grove interface
  • FM receiver with a tuning range of 64 MHz to 108 MHz covering Eastern Europe (OIRT), Japan, Europe and US bands
  • Lower power consumption
  • Multifunction button
  • LED Indicator
  • Headsets interface

Tip

More details about Grove modules please refer to Grove System

Platforms Supported

Hardware Overview

  • ①：Headsets interface:It can drive 16 ohm or 32 ohm earphone or audio。

  • ②：Multifunction button ：Change volume and select channel

    • Center：Open FM/Close FM（Keeping press 1S）
    • Up：volume add
    • Down：volume sub
    • Left：searching down
    • Right：searching up

  • ③：Grove Interface

  • ④：LED Indicator

    • FM Close：LED off
    • FM Open：LED light
    • FM Searching：LED flash

Usage

Part list：

  • Grove - USB Power
  • Grove - FM Receiver
  • Mini Cable
  • Audio

Resources


ArduinoWioBeagleBoneRaspberry PiLinkIt ONE

Caution

The platforms mentioned above as supported is/are an indication of the module's hardware or theoritical compatibility. We only provide software library or code examples for Arduino platform in most cases. It is not possible to provide software library / demo code for all possible MCU platforms. Hence, users have to write their own software library.

Help us make it better

Welcome to the new documentation system of Seeed Studio. We have made a lot of progress comparing to the old wiki system and will continue to improve it to make it more user friendly and helpful. The improvement can't be done without your kindly feedback. If you have any suggestions or findings, you are most welcome to submit the amended version as our contributor via Github or give us suggestions in the survey below, it would be more appreciated if you could leave your email so that we can reply to you. Happy Hacking!